STL file Trx4m Hilux 🚗 ・3D printing model to download・Cults

A 1984 Toyota Hilux designed to fit a traxxas trx4m.

Improves weight distribution, stability, articulation (Flex) and Clearance all round.

Fully 3D pritable and uses all existing screws excluding the battery holder. No holes need to be drilled or changed meaning 0 modifications to the stock chassis need to be made.

Works on a stock chassis with full clearance all round for stock sized tyres servo and axles.

Aditional materials needed
Glue suitable to fillament
screws for rear battery holder (same size as most screws on the vehicle.

All tools required come with the vehicle.
Uses existing battery tray for the esc
Does not use stock bumpers or rear shock tower

This is still a work in progress new components will be added and old ones may change.

Suggested components
59mm Injora shocks. These shocks work and increase artculation furthur.

Please contact with suggestions, bugs and faults.

I did not Design the cab or grill credit to https://www.thingiverse.com/dxx08/designs For those origionaly I did however slightly modify them.

Assembly instructions

You might need to split the chassis from the centre skid plate to fit the rear cab mount and tray in.

Preperation. Unblot rear shocks, shock towers, front and rear bumpers along with the braces for the bumpers.
1. Install the rear cab mount as shown in images
2. Install the front cab mount as shown in images
3. Glue the grill to the front of the cab. (thicker side up)
4. Put glue ontop of the front cab mount
5. Place the rear of the cab in the rear mount, lower the front of the cab down onto the front mound and centre.
6. Remove rear shock towers and replace with tray as shown in images.
7. Attach the rock sliders and bullbar as shown in images

Use a higher resolution for the tray sliders and bullbar for higher detail, I used 0.12mm